Woodworking Online Forum Index Woodworking Online

 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Locating a 1"-8TPI tap to match headstock

 
This forum is locked: you cannot post, reply to, or edit topics.   This topic is locked: you cannot edit posts or make replies.    Woodworking Online Forum Index -> rec.crafts.woodturning
View previous topic :: View next topic  
Author Message
jacabbage



Joined: 23 Aug 2005
Posts: 3
PostPosted: Sat Sep 03, 2005 11:40 pm    Post subject: Locating a 1"-8TPI tap to match headstock Reply with quote
I'm trying to locate a tap to use that matches my headstock, 1"-8TPI... any suggestions as to where I can get one reasonably priced? I will use it to make MDF chucks.
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
This forum is locked: you cannot post, reply to, or edit topics.   This topic is locked: you cannot edit posts or make replies.    Woodworking Online Forum Index -> rec.crafts.woodturning All times are GMT
Page 1 of 1

Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Head back to Woodworking Online
Forums Sitemap.